Sure-Flo manufacturers a complete line of suction fittings. Fittings from suction adapters to correctly size the suction line, suction elbows, couplers, down to foot valves, or strainers.
Well built, American made aluminum fittings that can handle the rigors of every pumping suction requirement.
(Click on any product image for details)
Elbows
Couplers
Eccentric Adapters
Concentric Adapters
Sure-Flo aluminum elbows are sealed by the compression of a rubber gasket, which is ample in size to assure a seal without excessive tightening. The elbow may be connected and disconnected repeatedly without replacement of the gasket.
90 Degree Elbow
45 Degree Elbow
| Part No. | OD Tubing Size | Type | Weight lbs. |
|---|---|---|---|
| SFE92 | 2" | 90° | 4 |
| SFE93 | 3" | 90° | 5 |
| SFE94 | 4" | 90° | 7 |
| SFE95 | 5" | 90° | 8.5 |
| SFE96 | 6" | 90° | 10.5 |
| SFE98 | 8" | 90° | 14.5 |
| SFE910 | 10" | 90° | 23 |
| SFE42 | 2" | 45° | 3.5 |
| SFE43 | 3" | 45° | 4.5 |
| SFE44 | 4" | 45° | 6 |
| SFE45 | 5" | 45° | 7 |
| SFE46 | 6" | 45° | 9 |
| SFE48 | 8" | 45° | 12 |
| SFE410 | 10" | 45° | 17 |
For joining two pieces of irrigation tubing with an air tight suction joint. This fitting is made from three aluminum castings and is sealed by the compression of two rubber gaskets. Easily and quickly tightened without damage to the tubing. Light in weight and free from rust. Tubing must be supported on both sides of the coupler.
| Part No. | OD Tube Size | Weight lbs. |
|---|---|---|
| SFC2 | 2" | 2.5 |
| SFC3 | 3" | 3 |
| SFC4 | 4" | 4 |
| SFC5 | 5" | 5 |
| SFC6 | 6" | 5.5 |
| SFC8 | 8" | 7 |
| SFC10 | 10" | 9.5 |
Pipe Threads to Tubing. These fittings permit the use of Sure-Flo suction fittings on any pump with threaded intakes from 2" to 10". Made from new standard NPT pipe thread with heavy gauge steel tubing welded to it. The fitting is then hot dipped galvanized. Frequently the suction line should be at least one size larger than the pump inlet.
When the tubing size is more than 1" greater than pipe size, the fitting is eccentric. Eccentric adapters should be installed straight side up, as pictured, to avoid air pockets from forming.
| Part No. | Male Pipe Size | OD Tube Size | Concentric (C) Eccentric (E) |
Weight lbs. |
|---|---|---|---|---|
| SFA152 | 1½" | 2" | C | 1.5 |
| SFA22 | 2" | 2" | C | 2.5 |
| SFA23 | 2" | 3" | C | 2 |
| SFA253 | 2½" | 3" | C | 3 |
| SFA33 | 3" | 3" | C | 4 |
| SFA24 | 2" | 4" | E | 3 |
| SFA254 | 2½" | 4" | E | 3.5 |
| SFA34 | 3" | 4" | C | 3.5 |
| SFA44 | 4" | 4" | C | 4.5 |
| SFA35 | 3" | 5" | E | 5.5 |
| SFA45 | 4" | 5" | C | 4.5 |
| SFA55 | 5" | 5" | C | 8 |
| SFA36 | 3" | 6" | E | 6.5 |
| SFA46 | 4" | 6" | E | 8 |
| SFA56 | 5" | 6" | C | 8 |
| SFA66 | 6" | 6" | C | 9 |
| SFA48 | 4" | 8" | E | 10.5 |
| SFA58 | 5" | 8" | E | 11.5 |
| SFA68 | 6" | 8" | E | 13.5 |
| SFA88 | 8" | 8" | C | 14.5 |
| SFA610 | 6" | 10" | E | 18.5 |
| SFA810 | 8" | 10" | E | 19.5 |
| SFA1010 | 10" | 10" | C | 24.5 |
These self-cleaning strainers are perfect for:
Lakes - Ponds - Streams
Debris clogging your pump's intake is eliminated when you install a Sure-Flo SCS2 self-cleaning strainer. Gone are those annoying trips into the water to scrub away leaves, algae, or aquatic plants. Because this screen is always clean, your pump can operate at maximum efficiency. It will provide all the water and pressure it was designed to deliver.
Only 35 PSI is required to operate the strainer.
A small amount of water is returned from the discharge line of the pump to the strainer. Inside, two special nozzles spray against the screen, causing it to revolve. Any debris (i.e. algae, aquatic plants, or leaves) attracted to the screen is blasted off every half revolution. Strainers operate in any position.
 |
 |
| Screen removed to show internal nozzles | SCS2 Plastic Screen |